Aquario Neo Co2 Diffuser Tiny

Aquario Neo Tiny Co2 Diffuser

Aquario's Neo diffuser features microscopic holes resulting in very fine and complete bubble diffusion.

The microbubbles produced allow better dissolution of Co2 in your water column, thus allowing aquatic plants to properly absorb Co2.

Sleek and sturdy, the Neo Diffuser is made of clear acrylic and is not easily broken during aquarium maintenance.

Similar to other diffusers, users can safely place it in the corner of a planted aquarium with the included suction cup.
Soak it in water for 30 minutes before use to produce smaller bubbles.

Product Features:

• Complete improvement (angel, articulation, length, diffusion area)
• Reduction of reflux pressure
• Smaller bubble than existing products
• Elastic and difficult to break PC (polycarbonate) pipe
• Available in 1 size
• Tiny Up to 10 gallons

IMPORTANT Notes:

• Ideal working pressure is 10 to 30 PSI (higher pressure could damage the diffuser)
• Attach the diffuser to your regulator and slowly increase the pressure to the desired level to avoid damaging your diffuser.
• Soak it in slightly warm (NOT BOILING) water for 30 minutes before use to produce smaller bubbles.
• When the bubbles start to get bigger, put it in a bleach solution (1 part bleach to 10 parts water) for 10 minutes and wash it several times with water to remove all the Bleach inside before use.

Is your diffuser gasket broken? A leak on the sides?
You can use a small amount of Thin Superglue (any thin cyanoacrylate glue) to repair the broken joint in seconds.

DO NOT put glue on the surface of the diffuser.
Wear gloves and be very careful when using the glue, it will bond the skin instantly!